How to clean a bong in 5 Simple Steps

Keepin constantly your bong clean is required for maintaining a smooth smoking experience. A clean bong won't only decrease the smell of one's smoke, but inaddition it helps to make sure that you're getting the most flavorful hits possible. Fortunately, cleaning your bong doesn't need to be complicated or time-consuming; with a couple of simple steps, it is possible to keep your bong in pristine condition. Let's break down joint filter.

Step 1 - Gather Your Supplies
Before you begin cleaning, ensure you have all the required supplies on hand. You'll need rubbing alcohol (at least 90% isopropyl alcohol), coarse salt, a classic toothbrush, paper towels or cloth towels, and q-tips or cotton swabs.

Step 2 - Empty Out Your Bong
The first step in cleaning your bong would be to empty out any remaining water and ash from the chamber. To achieve this, turn your bong inverted over a sink and gently shake it back and forth until every one of the liquid is gone. Make sure you dump any ash appropriately when you're finished.
 
Step 3 - Fill With Rubbing Alcohol & Salt Mixture
Once the chamber has been emptied out, fill it up with a combination of rubbing alcohol and coarse salt until it's about halfway full. The salt acts being an abrasive agent to greatly help loosen any stubborn residue that's left out after smoking. It's important to utilize rubbing alcohol that's at least 90% isopropyl alcohol so that it effectively dissolves any residue without leaving behind any unwanted odors or tastes in your piece. Allow this mixture to sit for about 10 minutes before proceeding with the following step.

Step 4 - Scrub Away Residue After the mixture has already established sufficient time to work its magic, grab your toothbrush (an old one works best) and start scrubbing away every one of the residue in the piece. Be sure to scrub thoroughly so all traces of residue are gone; if you can find still some stubborn spots put aside, repeat Steps 3 & 4 until they're removed completely.

Step 5 - Rinse & Dry Once all of the residue has been scrubbed away, rinse out your piece with hot water and use either paper towels or cloth towels to dry it off completely before using again. If you will find still some hard-to-reach areas left behind after rinsing, use q-tips or cotton swabs dipped in rubbing alcohol to obtain those spots cleaned up quickly and easily!



Conclusion:
Cleaning a bong doesn't need to be difficult; with your five simple steps, everyone can keep their pieces looking like new! All it takes is some rubbing alcohol (90%+ is best), coarse salt, a vintage toothbrush, paper towels/cloth towels for drying off afterwards, and q-tips/cotton swabs for getting into those hard-to-reach places! So don't be afraid—give it a take to today! With just a few minutes every now and then spent on maintenance tasks like cleaning your bongs properly—you'll make certain that each hit packs maximum flavor while keeping odors away!